Hello,
I have a 93 Ford Ranger 2wd and I need to do a total brake line replacement. I plan to replace all of the metal lines as well as the rubber distribution line that is mounted to the rear end. It looks like most of the line fittings are rounded off or rusted so bad that they will be unusable. From reading different articles and forum post it looks like I need 3/16 diameter line the whole way around, but I make mistakes and I'd appreciate being corrected if I'm wrong. I'm really unsure about the tube nut sizes especially with the mix of metric and standard sizes on the same chart. I was looking at different kits and wonder if the one that I have linked below would be a good choice? I included the nut sizes in the kit too. I would really appreciate help with that.

Thank you for any help. I really appreciate it. I'm in no way endorsing the kit that I linked to. It just seems to have what I think I need.

Fitting sizes:
I6 Fittings: 2 x 3/16” (7/16-24) Inverted Tube Nut, 10 x 3/16” (3/8-24) Inverted Tube Nut, 2 x 3/16” (1/2-20) Inverted Tube Nut, 2 x 3/16” (9/16-18) Inverted Tube Nut

Link for Kit: