Hey guys 05 ford ranger , just did the front brakes , rotors , pads , calipers . Everything went well until I stripped 1 of the slider pins , I over torqued it. Now I can’t get it out , it’s a torx 45 , I only have a 3/8” drive torx 45 . I tried but failed , stripped and over torqued . Any ideas ? Maybe step up to 1/2” drive ? I hate these slider pins , I’m use to the hex ones that are on the outside and easy to get a with a socket or wrench. These ones are inside and torx is annoying. Any help would be appreciated . Thanks