During the winter it looks like a pest chewed up wiring under the hood on the left side. The wiring harness going to the ABS module had wires
chewed though. I spliced all wires back together even some looked a little like they had been cut. Now I have a check engine light on and the OBDII
Will not connect to the vehicle. I am now suspecting that those wires were cut during installation to isolate the ABS brake module from the OBDII system.

Does anyone know where I might get a good pinout of the module electrical connector and or the wiring diagram.

I could make my best guess and cut a few that did look like they had been cut, but I would rather have some details.