Water in Exhaust pipe....
Water in Exhaust pipe....
During the cold winter months, i noticed when starting my truck, i would here a sound coming from the exhaust sounding like a pouring noise, and after a few minutes the noise would go away, but never saw any water or spots on ground.
today i started my truck and while it was idleing, i heard the noise and looked underneath and saw water driping from the exhaust pipe where a clamp is holding the pipes together, i would say it is behind the cat converter about where the bed starts behind the x-cab.
any ideas how water got in there and any way to get it out?
today i started my truck and while it was idleing, i heard the noise and looked underneath and saw water driping from the exhaust pipe where a clamp is holding the pipes together, i would say it is behind the cat converter about where the bed starts behind the x-cab.
any ideas how water got in there and any way to get it out?
Originally Posted by rwenzing
I'll bet that you don't have the original muffler on your truck. Ford OE mufflers have a small hole to allow the water condensation to drain. Many aftermarket mufflers do not.
well saying the truck is 13-14 years old now, i am sure it is not the original.
Originally Posted by Jeremy102579
come again?
One thing you can do to limit water buildup is drill a very small hole in your muffler as described by Bob (or you may have one that is clogged). You can also limit your short trips because they do not sufficiently heat up your exhaust to cause any excess water to convert back to steam.
Its very normal, like it has been said, now if you go out and it makes a huge puddle thats got a green tint to it, then you can stick your finger in it and taste it, it is sweet then you got a head gasket problem, otherwise its just normal condensation
And you probably have a leaky connection between the muffler and pipe, or pipe and CAT, whatever. When the "donut" when bad between my CAT and the pipe that joins it to the muffler, it dripped just after the cat when it was cold.
Thread
Thread Starter
Forum
Replies
Last Post
n3elz
General Technical & Electrical
11
Jan 3, 2005 05:31 PM





