4.0L OHV & SOHC V6 Tech General discussion of 4.0L OHV and SOHC V6 Ford Ranger engines.

what the fack!

Thread Tools
 
Search this Thread
 
Old Apr 3, 2008
  #1  
ranger_banger's Avatar
Thread Starter
|
Member
Joined: Nov 2006
Posts: 405
Likes: 0
From: cedar falls, iowa
what the fack!

ok, so i got my new starter today, put it on and go to crank it over and the same damn situation...one loud *** click! the old starter was shot for sure, but this is redonkulous. We pulled the belt off and everything wasn't seized, my buddy checked from underneath the truck and said he got the crank to spin. But seriously, this is getting annoying. I have an Optima Red Top in there and it still isn't doing anything.


any ideas from here guys?
 
Reply
Old Apr 3, 2008
  #2  
graniteguy's Avatar
Member
iTrader: (3)
Joined: Jul 2005
Posts: 3,221
Likes: 1
From: Texas
a starter for a manual is different than a starter for an automatic. For starters (pun intended), make sure you have the correct one
 
Reply
Old Apr 3, 2008
  #3  
duckbuster1888's Avatar
Member
iTrader: (1)
Joined: Aug 2006
Posts: 196
Likes: 0
From: Greenville, NC
and make sure if there is a little ground going to it it is connected or it wont start... i experianced it on my f150 once
 
Reply
Old Apr 3, 2008
  #4  
Alon's Avatar
Member
iTrader: (13)
Joined: Jun 2004
Posts: 2,555
Likes: 3
From: Long Beach, CA
how does the cable look going to it?

on my buggy i would just get a click and the cable was bad.
 
Reply
Old Apr 3, 2008
  #5  
IR0NS1N's Avatar
Member
Joined: Mar 2006
Posts: 886
Likes: 0
From: Mesa, Arizona
loose battery termals/cables ?
 
Reply
Old Apr 4, 2008
  #6  
rolsmojave3's Avatar
Level III Supporter
Joined: Jun 2006
Posts: 2,852
Likes: 3
From: Wisconsin
Battery dead? Either your not getting current to the starter, or it's not grounded. Check all relays and solenoids too.
 
Reply
Old Apr 4, 2008
  #7  
shagmail's Avatar
Member
Joined: Jan 2007
Posts: 132
Likes: 0
From: Millington Tn
I have gotten bad starters from the store. Once I got 3 in 1 day and they were all bad.

****
 
Reply
Old Apr 4, 2008
  #8  
ranger_banger's Avatar
Thread Starter
|
Member
Joined: Nov 2006
Posts: 405
Likes: 0
From: cedar falls, iowa
alright, well, I made damn sure to specify that they sent me a manual trans starter, but today we dug a lil deeping into it. Turned out that the ground on the solenoid broke itself somehow. So, with a little super glue it's all workin fine, and about time too! It was blowing white smoke for the whole few minutes it was running. We couldn't let it run too long because theres a nasty hole in the fuel line so gas was just pouring down from the tank.

SO thats the next thing. Is there just one line comming from the gas tank? and what size torx bit do i need to rip off the box?

Thanks a ton for everybodies help!
 
Reply
Old Apr 4, 2008
  #9  
rolsmojave3's Avatar
Level III Supporter
Joined: Jun 2006
Posts: 2,852
Likes: 3
From: Wisconsin
Get a new soleniod for starters.
 
Reply




All times are GMT -6. The time now is 06:33 AM.