Well today the bracket for the reclining part on the driver seat broke so I decided to get some new seats that I can put a four point harness on and the only company that I found that has mounting brackets for a ranger say that in my year model the only thing they have is for the four door model does anyone know if they are the same seats as in the two door model. What should I do for a center console seeing that both seat are going to be bucket seats should I get one out of an exploder or try to fab one up.

 

Seat mounts should be no different from a 2-door to a 4-door. But I'm not 100% sure. But yes do the full length explorer console it would look great!

 

^^The tracks are different......and the distance between the front and rear holes are longer on the reg cab models.

 

thanks i knew they might be a little different

 

BUT.....you can carry an xcab track over to a stdcab track and vice versa.....

Usually bolts or rivets holding the tracks to the frames.

 

In your sig it says you have a 2 door supper cab. I though all super cabs after 2000 were 4 door. Right?

I dont think it matters if its a supercab 2 door or a super cab 4 door but im not sure if your talking about a sing cab truck or a super cab.