Got down to the hardware store for some bolts and such, and got it up to where it should be, along with needing to set a time to get my exhaust raised up. I am going to be ordering some 20" long 2" to 3" cold rolled angle cut Scavenger tips, stainless steel of course.. and swing out to the exhaust shop.. might cost about 50 bucks give ro take to have it raised and new tips put on.. but no biggy =) The tips themselves will cost 50 bucks apiece as well -shrugs-



Onto a couple pictures for ya!

BEFORE:









AFTER:

 

about dang time man! lol.

2nd shot looks like a big *** dent on the driver bedside. lol.

 

Now fix those mufflers!!!

 

Hah yeah, its just how the post on the other side of the garage looks.. thats trippy :-) Oh noe's a hidden dent!!! *gasp*

 

Dang get some bigger tips on that thing, those look tiny. Looks a lot better

 

are those 1 inch exhuast tips?

 

you know i never even noticed that it was still down there lol, looks good, now get that exhaust redone cuz itll look 20x better

 

2" rolled non-slant cut tips.....appear to be smaller.

Mike...I think you need 2" in/3" out slash cut tips on that bad boy!

 

I say do it like I'm going to... Cut then where it starts to come down from the bend above the axle... before it goes vertical at the tips... It'll be like a rear dump...

 

Doh, my other reply didnt post.. hah..

I actually mentioned earlier:

I'm going to be getting it into the shop next week, getting some 20" long, 2x to 3 inch cold rolled angle cut Scavenger tips put on the rear, along with getting it mounted up a bit..

And yes, they are 2 inch tips right now, looked alot better before the lift.. but with the tires and truck and everythign gettin gbigger, it makes it appear ALOT smaller, haha

 

Looks much better.