1999 Ranger 2.5 Intake hoses..help!
#1
1999 Ranger 2.5 Intake hoses..help!
Took off intake manifold to replace EGR valve. Parts didn't come in on time so because I didn't mark my lines ( I know, dumb mistake), I have now forgotten what went where. Would someone happen to have a picture of the underside of one with everything hooked up? The coolant hoses are just the right length, so I believe they're fine. Does the PCV hose connect to throttle body or intake plenum? Any help appreciated!
Larry
Larry
#2
Okay. Found part of a line I was missing under some tools. This changes things for the better. So here's the new question. I have two places to connect hoses under the intake. One is on the intake itself and the other actually is on the throttle body. Which does the purge valve line connect to, and which does the PCV hose connect to? Just want to be sure before I tighten everything down.
Thread
Thread Starter
Forum
Replies
Last Post
BlackRanger04
OLD - Interior, Exterior, Electrical, & Misc.
9
06-06-2011 07:18 PM