OEM spindle snouts
#1
09-08-2018
Join Date: Sep 2018
Location: Pomona California
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
OEM spindle snouts
ok so this is going to sound like a stupid question but where can I buy OEM spindle snouts. I’ve been googling for hours.
The reason I’m looking for OEM is I’m planning on buying the camburg edge 6.0 kit and they said they can’t use the snouts from my aftermarket lift spindles.
Thanks in advance.
The reason I’m looking for OEM is I’m planning on buying the camburg edge 6.0 kit and they said they can’t use the snouts from my aftermarket lift spindles.
Thanks in advance.
#2
09-08-2018
Junkyard. If your truck is the Edge in your profile picture, you can get them from any 2001-2011 Ford Ranger Edge/Sport 4x2 with torsion bars. Maybe even 95-01 Explorers. I'm not sure about the 98-2011 coil spring Rangers though.
Be prepared though, those snouts won't come out with a hammer. They need to be pressed out.
Be prepared though, those snouts won't come out with a hammer. They need to be pressed out.
#3
09-10-2018
Join Date: Sep 2018
Location: Pomona California
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
#4
09-10-2018
Well you might still be able to source a set of stock Ford steering knuckles from a third party "new old stock" distributor, but that's about the only way you're going to get a set of brand new OEM snouts. And you'll still have to press them out of the OEM steering knuckles you have no use for.
#5
10-15-2018
Join Date: Sep 2018
Location: Pomona California
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
It’s been a while but I picked up some used spindles for a junkyard and I’m picking up the 6.0 kit from camburg tomorrow. I know I need to press out the snouts and put them in the new spindles and I have a press. How do I press them out and in to the new spindles without F’n everything up around me. It looks pretty straight forward any input helps.
#6
10-16-2018
It’s been a while but I picked up some used spindles for a junkyard and I’m picking up the 6.0 kit from camburg tomorrow. I know I need to press out the snouts and put them in the new spindles and I have a press. How do I press them out and in to the new spindles without F’n everything up around me. It looks pretty straight forward any input helps.
#7
10-16-2018
Join Date: Sep 2018
Location: Pomona California
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
#8
10-17-2018
Thread
Thread Starter
Forum
Replies
Last Post
yeatzee
OLD - Suspension, Tires, & Wheels
1
06-24-2012 07:13 PM
Want to Buy: Stock spindle/knucle's ! - CA
DonH
OLD - Suspension, Tires, & Wheels
22
05-04-2011 10:42 AM
