I have a 2004 ranger edge with the torsion bars tightened up about half way and a set of 2 inch blocks in the back and my upper control arms are very close to hitting the frame in the front. Does anybody know what to do? I need help!

 

yeah, decrank the torsion bars. otherwise there isn't anything you can do aside properly lifting the truck. mine are the same way, just keep the ABS sensor wires away from it. I've cut one in half before i relocated it

 

You can't buy different control arms? And I'm going to install a 4 inch suspension lift.

 

yes but theyre for a long/mid travel kit, not stock

 

probably farther away from hitting the frame than you think, jack the truck up from the xmember till the wheels are off the ground and check again. unless you installed longer shocks or put in the stupid shock spacer that comes with "levelling kits" you will be fine