A little outsider input
#1
A little outsider input
So after another annoying encounter with axle wrap today, i am finally in a mode to get my rear axle under control.
end game i would like to have 0-1" of lift and my rear end under control.
first direction: buy a James duff over leaf track bar and then install a belltech 6400.
second direction (im not entirely sure it will work for me) pull my rear leafs and lift block buy some 4-door explorer leafs, strap in an add-a leaf, and some belltech 6400's.
(Im not sure if it matters but my truck is an 02 with the 4-leaf tow setup)
My question is which direction should i be going in, is there an option better than the other? im ready to start getting this build going again, any and all help is much appreciated
end game i would like to have 0-1" of lift and my rear end under control.
first direction: buy a James duff over leaf track bar and then install a belltech 6400.
second direction (im not entirely sure it will work for me) pull my rear leafs and lift block buy some 4-door explorer leafs, strap in an add-a leaf, and some belltech 6400's.
(Im not sure if it matters but my truck is an 02 with the 4-leaf tow setup)
My question is which direction should i be going in, is there an option better than the other? im ready to start getting this build going again, any and all help is much appreciated
#3
#6
Thread
Thread Starter
Forum
Replies
Last Post
Crein2009
General Ford Ranger Discussion
6
05-24-2009 10:42 PM
benny
General Technical & Electrical
8
08-30-2004 12:50 PM