im in the process of installing new upper ball joints and i was going to install the cam kit at the same time... is there anything special involved in this install or do i just put it in and then have the truck aligned?

 

Just put them in and take it to get aligned.

Hell when I dropped the front of my truck from stock to 5.5 inches which included all new upper and lower arms and coils I installed a 2 degree camber kit in so they wouldnt rape me with one of theirs they said nothing and aligned it.

 

ok... i bought the kit from a napa service place across the street from my office where im gonna take it to get aligned... they gave me the shop rate of $15 for both kits and its $59 to align after i finish with the ball joint install sometime in the next few days... the sooner the better since the benz doesn't have a/c and its 9000 degrees here in mississippi

 

Yeah it was around 30 something after tax for the camber kit on both sides for my truck and I bought them from napa to. What degree did you go with? And is napa doing the alignment?

 

Just curious, how much does it usually cost to buy a camber kit and have it installed? When the dealership put one on my truck the invoice showed about $400. I didn't pay a dime for it, but I'm just curious how much it really costs to install.

 

they are usually around 30 bucks for both side and basically pulling off the old camber washers and putting new ones in..

 

i think it was 2 1/4 degrees and yeah im gonna have them do it since i can walk across the street to my office when i drop the truck off

 

i just finished them... it took about 3 hours to do both sides with hand tools including a trip over to bay st louis to see the new bridge and get some locktite for my caliper bolts