Truck leaning
#1
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
Truck leaning
So i was outside today, i went to measure the gaps between my tires and fender because this saturday i had coil spacers installed. The measurements used to be around 7" all around. I noticed that the front drivers side was 8" and the front passengers side was 8 3/4", and the rear was about the same just an inch less on front and rear. So i went and looked, and sure enough, its sitting all weird and leaning to the left. wtf? how could this have happened and wtf do i do?
#4
#6
If you have coil spacers it can't be the t-bars. So make sure it is on level ground like in that car port/garage in the pic and remeasure. If it is still like that then i would say its the full tank or worn springs. And just give everything a good look underneath to make sure everything is ok.
#8
#9
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
#11
#12
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
#15
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
#17
#18
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
#21
#22
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
#24
Join Date: Feb 2007
Location: Woodland Hills, California
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts