Need measurements.
#1
08-09-2007
Unregistered User
Posts: n/a
Need measurements.
I believe I have found a ' cheat ' of sorts for something but I need some measurements.
What I need is for someone with a 2wd XLT to take a measurement of their upper control arm covering the distance between the bushings.
If possible, also measure the distance of the upper bushing itself between the 2 connecting plates.
What I need is for someone with a 2wd XLT to take a measurement of their upper control arm covering the distance between the bushings.
If possible, also measure the distance of the upper bushing itself between the 2 connecting plates.
#5
08-09-2007
Unregistered User
Posts: n/a
Originally Posted by nbro3232
trying to use 2wd uppers?
I remember matching the XLT uppers ScottyG ( gaybriel ) gave me with the Edge ones I had.. and I ( cant remember ) if they were the same distance. I went to grab one of his old control arms BUT.. it was bent and not ' straight ' enough for an accurate measurement.
The balljoint pin is the same ( perfect fit ).
#6
08-10-2007
Originally Posted by D.
Something like that.
I remember matching the XLT uppers ScottyG ( gaybriel ) gave me with the Edge ones I had.. and I ( cant remember ) if they were the same distance. I went to grab one of his old control arms BUT.. it was bent and not ' straight ' enough for an accurate measurement.
The balljoint pin is the same ( perfect fit ).
I remember matching the XLT uppers ScottyG ( gaybriel ) gave me with the Edge ones I had.. and I ( cant remember ) if they were the same distance. I went to grab one of his old control arms BUT.. it was bent and not ' straight ' enough for an accurate measurement.
The balljoint pin is the same ( perfect fit ).
Thread
Thread Starter
Forum
Replies
Last Post
redranger4.0
General Ford Ranger Discussion
4
04-16-2009 02:46 PM
