Ok so i got my spindle lift yesterday from UPS and the kit was a 3" lift....the blocks that came with it says that they are lowering blocks.....all i have to do is put them on the opposite side of the leaf springs and itll lift it am i correct?? I just wanted to make sure that they werent different than lifting blocks....it came with blocks and u-bolts and screws and whatever is that all that is needed??? someone said soemthing about a plate for the blocks but i didnt get one....help me out guys....thanks!! o and can someone send me some insgtructions on how to put the spindles in...thanks

 

Are these for an Edge or an XLT?

Also, check out this...

https://www.ranger-forums.com/forum2...ad.php?t=16252

Brenton

 

yeah they're the same kinda blocks.. for the rear, just unbolt one side at a time and slip the blocks in. it's a lot easier with a big *** jack stand. then for the front, just unbolt the brakes, take off all the castle nuts on the spindle, remove the stock spindle and install the new one! then check your turning radius and modify your lower control arms as necessary with a grinder. piece o cake..