Oil Pressure Sending Unit Location
#1
#2
#3
I could've tapped into the wrong port. I found an sending unit drivers side front and it had one green wire. When I disconnected the wire the oil pressure on the stock gauge would drop all the way. When I plugged it back in normal again. I figured this was it!
I install my gauge and it spikes to about 40-50 range then after about 10 min of running the engine it dropped back down to 20-25 range.
Now my problem is when I shut the engine off the gauge stays in the same exact place and during my 10 mile drive home I didn't really see any movement. What did I do wrong?
I install my gauge and it spikes to about 40-50 range then after about 10 min of running the engine it dropped back down to 20-25 range.
Now my problem is when I shut the engine off the gauge stays in the same exact place and during my 10 mile drive home I didn't really see any movement. What did I do wrong?
#4
#7
Some have teed the stock and aftermarket sending units to keep both gauges functional and the light off.
Thread
Thread Starter
Forum
Replies
Last Post
pbcanney
4.0L OHV & SOHC V6 Tech
10
03-20-2018 04:53 PM
FRXLT
2.9L & 3.0L V6 Tech
29
01-31-2012 10:05 AM