What is this part 2006 2.3 engine.
#5
#9
Oh yes it can. Just did it. Does not run well at all, but it will crank and run just fine. Lot of puffing and air coming from that hole but it told me what I wanted to know. If the engine would even crank at all, even if I had that part.
That part is 60 bucks and I did not want to waste funds on that, IF i had to replace the engine. junk yard engines come with most of the stuff still attached.
That part is 60 bucks and I did not want to waste funds on that, IF i had to replace the engine. junk yard engines come with most of the stuff still attached.
#10
#11
#12
Well, I guess we could have elaborated on "how" the truck will run without an IAC and not so much "will" it. Sure, it'll start and choke, but the component that regulates the air passing by the close off throttle body is not allowing the proper amount to go through thus, choking the engine. Idles will go up and down and be erratic until you open up the throttle, then all is fine....but let the throttle close and you'll choke off the motor and start the idle jump again.
You can try to spray brake cleaner in the IAC to free up the spring that is most likely gunked up with carbon. This may give you some more time until you get the new part, but may not work if the spring is jammed up too badly.
You can try to spray brake cleaner in the IAC to free up the spring that is most likely gunked up with carbon. This may give you some more time until you get the new part, but may not work if the spring is jammed up too badly.
#13
What spring? I did not have a IAC at all, none. Was gone when I bought the truck.
I put the part on and trucks cranks and runs a little better. Has what I would call a miss. Not sure what it could be, but did run long enough to hear no bad noises, like rods or other grinding.
Truck sat for 2 years and not moved. Has 116k miles.
I am going to pull the plugs tomorrow and see what they look like.
I put the part on and trucks cranks and runs a little better. Has what I would call a miss. Not sure what it could be, but did run long enough to hear no bad noises, like rods or other grinding.
Truck sat for 2 years and not moved. Has 116k miles.
I am going to pull the plugs tomorrow and see what they look like.
Thread
Thread Starter
Forum
Replies
Last Post
new2tubes
General Technical & Electrical
2
05-05-2015 08:36 AM
Police Interceptor
OLD - Interior, Exterior, Electrical, & Misc.
15
10-08-2013 12:29 AM