I got hit can this be fixed.
#3
#6
dont wanna poke fun or make light of a serious situation but dude you have a hover craft wheel now. tell me how it rides ha.
and that seems repairable. new A-arm and whole steering assembly/brakes (basically a new front end and if the frame aint bad just new panels and doors and hood.
cost of repair might not = insurance of totaled truck
and that seems repairable. new A-arm and whole steering assembly/brakes (basically a new front end and if the frame aint bad just new panels and doors and hood.
cost of repair might not = insurance of totaled truck
#8
#15
#17
yea its toast...i work at a body shop so let me offer you my reasoning
the rocker panel is ****ed...needs replaced
lower a pillar is ****ed...needs serious attention...and you cant see whats hiding under the fender that a pillar might even need to be replaced if its crushed under there and thats a big job
im willing to bet the frame is swayed
and there might even be some body mounts that need replacing
were you found at fault?
the rocker panel is ****ed...needs replaced
lower a pillar is ****ed...needs serious attention...and you cant see whats hiding under the fender that a pillar might even need to be replaced if its crushed under there and thats a big job
im willing to bet the frame is swayed
and there might even be some body mounts that need replacing
were you found at fault?
Last edited by djfllmn; 10-19-2011 at 03:59 PM.
#19
#20
Its done for man. how fast where you hit? anything over like 20 MPH and you've got yourself a bent frame.
i see this all day, everyday. It may not look like it, but i'm willing to bet its tweaked. front cab corner probably.
in addation.
Door skin, Fender, Ball joints, Brake line, CV shaft, Tie rod end. Rocker panel (could be scalped in)
if you can find a good frame guy, i'd go for around 2k with Used body parts, new suspenions items, and frame with labor.
i see this all day, everyday. It may not look like it, but i'm willing to bet its tweaked. front cab corner probably.
in addation.
Door skin, Fender, Ball joints, Brake line, CV shaft, Tie rod end. Rocker panel (could be scalped in)
if you can find a good frame guy, i'd go for around 2k with Used body parts, new suspenions items, and frame with labor.
Thread
Thread Starter
Forum
Replies
Last Post
gerneml
General Technical & Electrical
0
09-26-2014 08:40 AM
BlkTremor02
Forced Induction & N20 Tech
16
08-02-2005 08:52 AM