Some new "mods" if you will...
#1
Join Date: Mar 2005
Location: Acworth, GA
Posts: 2,099
Likes: 0
Received 0 Likes
on
0 Posts
Some new "mods" if you will...
Driveshaft is longer. 2" longer. Alot of people probably wish their shaft was 2" longer, for free.
Some warn premiums. Putting the Milemarkers on jamies jeep (project xj).
And can anyone guess what this is under the hood? (I sure as hell hope so)
What happens to pinion bearings if you forget to put oil in your diff??
Say bye bye D60, the outer pinion bearing has welded itself to the pinion. We heated it up and beat the **** out of it with a huge *** sledge hammer, we successfully destroyed the pinion (made it about 2" shorter) and it didn't budge.
Some warn premiums. Putting the Milemarkers on jamies jeep (project xj).
And can anyone guess what this is under the hood? (I sure as hell hope so)
What happens to pinion bearings if you forget to put oil in your diff??
Say bye bye D60, the outer pinion bearing has welded itself to the pinion. We heated it up and beat the **** out of it with a huge *** sledge hammer, we successfully destroyed the pinion (made it about 2" shorter) and it didn't budge.
#6
#11
Well, the quality of the picture (the one under the hood, that is) leaves something to be desired, lol.
Sorry about that diff! This is, for me, a constant worry. I am SO absentminded about stuff sometimes, I figure it's just a matter of time before I do something like that.
Sorry about that diff! This is, for me, a constant worry. I am SO absentminded about stuff sometimes, I figure it's just a matter of time before I do something like that.
Last edited by n3elz; 05-02-2006 at 06:31 PM.
#15
Join Date: Mar 2005
Location: Acworth, GA
Posts: 2,099
Likes: 0
Received 0 Likes
on
0 Posts
#17
Originally Posted by 034x4
The d60 is out of my friend jeremy's xj.
We are going to try and torch the bearing off the pinion and see if we can scavange at least the housing to be used again, but it's highly doubtful. It's probably time for a new d60. He just welded the caliper brackets for rear discs on there too.
We are going to try and torch the bearing off the pinion and see if we can scavange at least the housing to be used again, but it's highly doubtful. It's probably time for a new d60. He just welded the caliper brackets for rear discs on there too.