Pics of rangers on 32s w 2 inch lift, stock height for edge?
#1
Pics of rangers on 32s w 2 inch lift, stock height for edge?
Been looking and having difficulty locating them, most aren't labeled!
I did torsion twist for I think 2 inches. From fender to ground the front js 34.5 inches, and 35 in the rear. Factory was significantly less but when I lifted I measured incorrectly to wheel ml to ground, so I dont know how much I lifted it.
Anybody know what a 2003 ranger tremor (edge) 2wd sat at factory height? (and yes I know the back is unchanged and I lifted the front to match).
Also just ordered 32s (265/75/16)
Post pics of this setup or one comparable
Thanks guys
I did torsion twist for I think 2 inches. From fender to ground the front js 34.5 inches, and 35 in the rear. Factory was significantly less but when I lifted I measured incorrectly to wheel ml to ground, so I dont know how much I lifted it.
Anybody know what a 2003 ranger tremor (edge) 2wd sat at factory height? (and yes I know the back is unchanged and I lifted the front to match).
Also just ordered 32s (265/75/16)
Post pics of this setup or one comparable
Thanks guys
Thread
Thread Starter
Forum
Replies
Last Post
dixie_boysles
Wheels & Tires Semi-Tech
14
08-31-2009 11:07 PM
panzer
Wheels & Tires Semi-Tech
6
07-31-2007 12:45 PM