no power to windsheild washer pump
#1
no power to windsheild washer pump
Hi all,
I have a 1989 ranger 2 wheel drive, 2.9L.
I have now power to the windshield washer pump. Can't hear the pump working when pressing the washer on turn indicator. Used test light at plug at washer motor and no power. Ran jumper wires to washer pump from battery and the pump works, squirts fluid just fine.
Pulled covers from steering column, and unplugged multifunction switch. Put power to the "purple/lime green" wire that goes to the washer pump, and it squirts just fine. I guess the MF switch is NG, but is there a way to clean the contacts in the switch, or is it easier to just buy a new MF switch? Everything else in the switch works fine.
Thanks
Lester
I have a 1989 ranger 2 wheel drive, 2.9L.
I have now power to the windshield washer pump. Can't hear the pump working when pressing the washer on turn indicator. Used test light at plug at washer motor and no power. Ran jumper wires to washer pump from battery and the pump works, squirts fluid just fine.
Pulled covers from steering column, and unplugged multifunction switch. Put power to the "purple/lime green" wire that goes to the washer pump, and it squirts just fine. I guess the MF switch is NG, but is there a way to clean the contacts in the switch, or is it easier to just buy a new MF switch? Everything else in the switch works fine.
Thanks
Lester
#3
could just go to a jy and snag one
tells you how to remove them in here
https://www.ranger-forums.com/showth...unction+switch
tells you how to remove them in here
https://www.ranger-forums.com/showth...unction+switch
Thread
Thread Starter
Forum
Replies
Last Post
wildswing
General Technical & Electrical
4
05-09-2013 08:49 PM
jimabbett
SOHC - 2.3L & 2.5L Lima Engines
3
12-27-2011 08:00 AM
zabeard
General Ford Ranger Discussion
8
12-17-2008 10:35 AM