idiot lights sblinking on and off
#1
idiot lights sblinking on and off
My 1991 Ranger does not have ABS, yet my "rear antilock" idiot light keeps turning on and then off, it does this several times when im driving around, sometimes staying on for mintues. Also, my "e-brake" light does the exact same thing, sometimes at the same times as the "rear antilock" light. I disconnected the one wire harness that plugs into the pivot point of the e-brake arm in hopes to just turn off the "e-brake" light but it still does this.
Any ideas? Thx
Any ideas? Thx
#3
#4
All 1989 And newer Rangers have ABS.
- 1989~1994: RABS (1-channel, 2-wheel, rear-only ABS) was standard factory equipment on all U.S. production Rangers.
- 1995~2000: 4WABS (3-channel, 4-wheel ABS) became available depending on option content. RABS continued to be standard.
- 2001~present: 4WABS + EBFD (Electronic Brake Force Distribution) has been standard factory equipment. RABS discontinued.
#5
All 1989 And newer Rangers have ABS.
- 1989~1994: RABS (1-channel, 2-wheel, rear-only ABS) was standard factory equipment on all U.S. production Rangers.
- 1995~2000: 4WABS (3-channel, 4-wheel ABS) became available depending on option content. RABS continued to be standard.
- 2001~present: 4WABS + EBFD (Electronic Brake Force Distribution) has been standard factory equipment. RABS discontinued.
#7
i still have a hard time believing a truck this old and this basic would have ABS, as my 96 XJ didnt have any ABS at all. where did you find that data?
and yeah, i was thinking tape would be my fix
#9
i was wondering about that cause i couldnt find any evidence of ABS near the master cylinder.
i still have a hard time believing a truck this old and this basic would have ABS, as my 96 XJ didnt have any ABS at all. where did you find that data?
and yeah, i was thinking tape would be my fix
i still have a hard time believing a truck this old and this basic would have ABS, as my 96 XJ didnt have any ABS at all. where did you find that data?
and yeah, i was thinking tape would be my fix
If you don't actually want to see the black tape, take that cover piece off the dash and put the tape on the back side.
#11
Thread
Thread Starter
Forum
Replies
Last Post
FMD
General Technical & Electrical
9
05-08-2008 07:54 PM