Clutch pedal issue
#1
Clutch pedal issue
I am able to lift my clutch pedal up past the resting point. I looked near the pedals and the clutch interlock switch is loose and dangling around. It still shifts and starts but it needs to be fixed. I don't understand how the clutch interlock bypass switch is suppose to be held in place.
The hanes manual shows some retainer clip but I never seen it before when I have been laying on the floor board in the past for other repairs/mods. I also pulled up half the carpet to see if any such clip fell under there, nothing found.
The hanes manual shows some retainer clip but I never seen it before when I have been laying on the floor board in the past for other repairs/mods. I also pulled up half the carpet to see if any such clip fell under there, nothing found.
#3
RF Veteran
iTrader: (1)
#4
I searched the Internet early this morning and some jeep guys said if the pushrods comes out you need to replace the master cylinder, at least on a jeep. I went ahead and ordered a new one and it should be here by Wednesday. I move to my college apartment Thursday so hopefully the part isn't late.
I couldn't find any clip on the floor of my truck or under the carpet. Will have to see what the new part looks. Until then I'll have to drive my mom's Corolla.
I couldn't find any clip on the floor of my truck or under the carpet. Will have to see what the new part looks. Until then I'll have to drive my mom's Corolla.
#6
That's what I kind of figured. I ordered a new master this morning because I really need it before I move into school.
Thread
Thread Starter
Forum
Replies
Last Post