Zabeards SAS Thread
#578
#581
#587
Being that you are getting closer and closer to finishing. I just see one thing that is so small compared to what you should be worrying about now, that I would recommend. Go buy a set of gap guards, or get splash guards for both front sides. With bigger tires in the future I'm sure, your engine bay is gonna be a mess!
#589
#592
Originally Posted by zabeard
ah im not too concerned about it right now. maybe later, right now i just want to get it out of the garage and down the road. lol
Awesome progress!!!
Excuse the newb in me, but why is your coil bucket shaped with a pipe hanging down? I thought there was supposed to be the flat part there, up high...maybe I'm wrong, I dunno anything about coils!
#593
Originally Posted by casfz1
Then what are you doing on here get out there and finish it.lol
cant, i need to buy 8-3 wire for the new welder so we can run 220 over to the garage.
the 110 welder just isnt going to cut it in several areas coming up
i need a 41/64 drill bit
i need some pieces made in the lathe.
i need some 1/2" plate
i need brake lines
i need shocks
i need power steering lines matted
lol that is just part of the list haha
#594
Originally Posted by jrpro130
haha, I know that feeling.
Awesome progress!!!
Excuse the newb in me, but why is your coil bucket shaped with a pipe hanging down? I thought there was supposed to be the flat part there, up high...maybe I'm wrong, I dunno anything about coils!
Awesome progress!!!
Excuse the newb in me, but why is your coil bucket shaped with a pipe hanging down? I thought there was supposed to be the flat part there, up high...maybe I'm wrong, I dunno anything about coils!
i will weld a circular plate at the correct place on that tube and then cut the tube short.
i just made it long so i could have enough adjustment.
#595
#597