Spindle's question
#1
Spindle's question
Ok not as tough as it might sound. I'm completely re-doing my suspension and am dropping the fab-crap lift that is currently on it. Now back when I purchased this one I was looking at a Procomp set of spindles, however now procomps website is showing nothing as far as a spindle lift for my 01 EDGE. I refuse to go back to Fabtech and was wondering if anyone knows why Procomp's website doesn't show a lift. Did they discontinue it or whats going on?
#3
#4
Originally Posted by Sychodemeanor
Ehhh don't like the wider front spread and to be honest I didn't abuse it too much, however it could have been abused before I got it since I did purchase it used. Either which way I'm just leaning towards a different route on it.
#5
*sigh* well I was looking at getting a complete kit and it looks like Fabtech is the only one with a complete new kit. I guess I'll be going back to them. I'm also going to change my rim size too. I'm going to drop from a 15x12 to a 15x10 in hopes that is will take some of the strain off the front end.
#10
#12
#13
#14
Originally Posted by Sychodemeanor
Also does anyone have a part number or dealer for the chevy shackles if that is the route I have to go. I'm thinking that with the factory block, the AAl from Fabtech and the shackle I should be about even on lift correct?
2 inch Chevy drop shackle
part # BEL-6400
Available from http://www.summitracing.com/
and here is my truck with the fabtech spindles procomp aal's and chevy shackles on 31's (im getting 33's in a few weeks)
Thread
Thread Starter
Forum
Replies
Last Post