Doing a 3" PA lift on my 2010 4x4
#1
Join Date: Jul 2010
Location: Oakville, Ontario
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
Doing a 3" PA lift on my 2010 4x4
Hey guys,
I'm going to be lifting my 2010 tomorrow with the PA 3" bl. Any last minute pointers anyone can think of? I've read through the the tech info extravaganza as well.
I have a MAP torch for the body bolts for the loctite, jack and axle stands, ratchet set and air tools, every wrench under the sun, your normal tools. Have a guy coming to help me (I'm in Oakville ON) as well and he's done a couple lifts so we should be good to go! I've also been spraying the body bolts with WD-40 or Jigaloo every couple days for the past few weeks.
I bought some step guard from home depot to MacGyver some rear gap guards as well.
I'm going to be lifting my 2010 tomorrow with the PA 3" bl. Any last minute pointers anyone can think of? I've read through the the tech info extravaganza as well.
I have a MAP torch for the body bolts for the loctite, jack and axle stands, ratchet set and air tools, every wrench under the sun, your normal tools. Have a guy coming to help me (I'm in Oakville ON) as well and he's done a couple lifts so we should be good to go! I've also been spraying the body bolts with WD-40 or Jigaloo every couple days for the past few weeks.
I bought some step guard from home depot to MacGyver some rear gap guards as well.
Thread
Thread Starter
Forum
Replies
Last Post
rngprerunner
Vehicle & Meet Videos
6
05-04-2010 08:08 AM
n3elz
Suspension Tech
21
12-22-2005 11:35 AM