gauges installed
#1
gauges installed
hey guys i just installed water temp and oil pressure gauges. Just wondering if it was ok to splice into the wire going into the factory sending unit. and also what should my gauges be reading? oil pressure is at 100 psi and the water temp is right around 100?? please let me know!
#5
#6
#11
#12
well i got them done, sorry no pics. It was too dark. I got the ultra lites and the dual pod on the a pillar. for some reason my oil pressure is reading over 100. Truck is running fine. I know before on my dash lights the check gauge was on which was part of the reason i got aftermarket gauges but i spliced into the wires by the current sending units. Any suggestions? I got water temp and oil pressure. the water temp one seems to be ok.
#13
all was well last night. Today got up wnet to class and all that. gauges were working fine. Somewhere in the mix, my fog lights on my truck that were on anytime the key was in the truck did not turn on and my headlights turned on with my parking lights and then stayed on when i flipped the headlights on. I have off road lights too and those worked ok. What went wrong???
#16
When installing an aftermarket oil pressure gauge on any engine, you have to remember that the pressure will depend on where you locate the sender. I have 3 oil pressure gauges on my evo (2 aftermarket ones, and 1 factory sender that pins to the ECU) and all 3 read different due to location. This is common.
#17
#18
When installing an aftermarket oil pressure gauge on any engine, you have to remember that the pressure will depend on where you locate the sender. I have 3 oil pressure gauges on my evo (2 aftermarket ones, and 1 factory sender that pins to the ECU) and all 3 read different due to location. This is common.
Thread
Thread Starter
Forum
Replies
Last Post