what pic?1 2 3 4? they are to much a close up?

 

The 2nd pic is the guard that is covering the line that has no fluid running through it, were I found it dripping after I filled it up and took it for a ride down the street. I checked the two lines coming out of the Master Cylinder, They run right into the abs pump I forget what that is called. Than 3 lines come out of there I followed them as far as I can see and no leak.Like I said in a past reply there is a little brake fluid on the inside of the front driver tire but most of it is on the shield right below it. So it has to be in this area.

 

Ok, guessing from the ABS there’s a Right F, Left F , and rear lines. You’ll find it

 

Do You know which one is which?

 

you would have to follow them, shouldn't be too hard. just right, left and rear.

 

I know I am slow, triple bypass and my helper has MS. I had my helper pump the brakes, I had cardboard underneith. It was coming down more toward the left -center of the truck. Than it went to the drivers side than toward the rear. So its the line that comes off the abs pump. Can I order that line or do I have to make it. I believe its the center one on the ABS pump. If I have to make it how much do you think it would be to have a mechanic install all 3?

 

will this fit my truck even though it says 2wd and rwabs and mine is 4wd and 4wabs.

 

if youre sure thats it, have someone remove it and take it to NAPA or other good parts house. see if they can match it up or order it.

 

who has this kit?

 

Ebay ,Amazon and a few others. I went to advance auto they said they dont have any pre bent brake lines.It asks what truck I put 1995 Ford Ranger XLT 4.0, but it didnt ask if its 4wd and 4 wheel ABS

 

you need to take off the one thats leaking, then take it to a parts house. good places have lines but they are straight. you will straighten yours out and match it up with one that fits. then bend the new one to fit.
or get a kit and replace all of them?

 

The kit I mentioned above would that fit? I am not putting it on the hub, and if I had to change that line I believe it goes straight back from the piece that is leaking.

 

F57Z-2264-AG is the part # of the brake line I need to replace.Ford Parts Giant. It shows a picture of the line and part of it is rubber. Can I make this part or do I need that part so its flexible? This site says its discontinued!!!

 

you need to take it off, then see if someone can match it.

 

Unfortunatlly I am not able to fix this myself. I did find the line that was leaking. Its probably the middle one on the abs booster, runs down the middle of the truck and then connects to the back braks.I brought it to a nearby mechanic, how much do you think it will cost to fix