Ok, got the cash, just got the headers put in. now time to finish off the exhaust.

I want a flowmaster super 40 or 44, that has been decided. I also want 2.5" from cat back, Single in, dual out stubbed out by the spare underneath.

Is it better off to get a shop to pipe this themselves, cash wise? i looked on flowmasters site and they dont seem to have a system for our rangers? Wouldnt buying an already pre-fabbed system like magnaflow, cherrbomb and all those other ones be cheaper? Then all the shop has to do is hack off the old and throw the new in, right?

Just curious what your experiences are.. im pretty set on getting that flowmaster setup but im also curious bout the cost and install time.

 

I'm having good results with my Folgers can. about 20HP and 15MPG

/end joke

I have the Flowmaster 40, I like it a lot, cost depends on where you get it

Are you going to install it yourself?

 

You can put on a Magnaflow kit yourself. However, it would be cheaper to just buy a muffler and have a shop run the pipes. Stainless pipes sure are nice and are probably needed where you are though.

 

I have a magnaflow muffler with 2.5" in and dual 2.25" out, all stainless, hand made for $450. Cheapest I could find the magnaflow kit for was $780