tweeter install
#1
tweeter install
First off where is a good locationto slap the puppies and the ones I wanna get are alpine ones they come with a crossover. where will the wires need to be ran and what is the corssover for
Can I run these to my amp under my seat and be good or do they need to run to the door speakers
Can I run these to my amp under my seat and be good or do they need to run to the door speakers
#3
#4
if you have open channels on your amp, i would run them off your amp(if the power ratings fall in the range of the tweeters) so that way you can set the highpass lvl to the right freq. and tune them a bit more and get a more clean sounding high.
i may be a$$ backwards, but the way i described makes sense to me..
i may be a$$ backwards, but the way i described makes sense to me..
#5
#6
alrighty stereo's are my thing so i will break it down for you. you want your tweeters out in front of you, i general mounts them on the A pillars NOT high tho down toward the dash, see what sounds best on axis or off axis so pointed at you or pointed toward the other A pillar, i point them toward the center of the car. the crossover is there to do just that cross the speakers to the correct levels, tweets are for the highs, mids for the mids and subs for the lows. you can put those in the doors or under the seat or up in the dash. you can run them to an amp, set the crossover on the amp to to the fullrange setting and set the crossover to play between 82hz-120 or 130hz. also dont put tweets up high behind you it raises the soundstage and pushes it way back in back of you. you want it chest level out and front of you.
#7
so in reply to your pm. i dont feel like drawing a diagram because it is easy to explain, from the amp run the speaker wire to the crossover and hook it up to the input then from the mid output on the crossover run speaker wire from there to the mid, then do the same for the tweeter from the tweeter output. simple.
#8
Thread
Thread Starter
Forum
Replies
Last Post