5R55E TSS help!!!!
Thread Starter
|
Member
Joined: Jun 2019
Posts: 34
Likes: 2
From: Victorville
5R55E TSS help!!!!
1999 4.0 ohv with 5r55e code is P0715 , Trans is in limp mode, banging into every gear. Tested resistance of turbine shaft speed sensor and it is within spec, 94 ohms to be exact. Where do i go now , ive cleaned all connectors on trans and the 50 pin connector. On my scan tool in still have 0 rpm on TSS and OD drum. Any help is appreciated. Thanks in advance. Oh also did a filter change and drain and fill but didn't help obviously haha.
Last edited by 99TRanger4x4; Jul 23, 2022 at 11:58 PM.
Member
Joined: Mar 2020
Posts: 850
Likes: 224
From: US
1999 4.0 ohv with 5r55e
...code is P0175
...Trans is in limp mode, banging into every gear
...resistance of turbine shaft speed sensor and it is within spec, 94 ohms
...cleaned all connectors on trans and the 50 pin connector
...scan tool in still have 0 rpm on TSS and OD drum.
...Any help
...did a filter change and drain and fill but didn't help
...code is P0175
...Trans is in limp mode, banging into every gear
...resistance of turbine shaft speed sensor and it is within spec, 94 ohms
...cleaned all connectors on trans and the 50 pin connector
...scan tool in still have 0 rpm on TSS and OD drum.
...Any help
...did a filter change and drain and fill but didn't help
Not Transmission; possibly bad Injector\Plug+Wire\VacLeak\UpStreamOxSensor\...
Thread Starter
|
Member
Joined: Jun 2019
Posts: 34
Likes: 2
From: Victorville
****, dyslexia kicked in , i made the correction. Thanks for pointing it at.
Member
Joined: Aug 2022
Posts: 1
Likes: 0
From: Renton, Washington
1999 4.0 ohv with 5r55e code is P0715 , Trans is in limp mode, banging into every gear. Tested resistance of turbine shaft speed sensor and it is within spec, 94 ohms to be exact. Where do i go now , ive cleaned all connectors on trans and the 50 pin connector. On my scan tool in still have 0 rpm on TSS and OD drum. Any help is appreciated. Thanks in advance. Oh also did a filter change and drain and fill but didn't help obviously haha.
I had the same p0715 code, got the trans opened up and the reluctor wheel had sheered off its mount. Wasn’t the actual sensor that failed.
Thread Starter
|
Member
Joined: Jun 2019
Posts: 34
Likes: 2
From: Victorville
well ****, i guess i got lucky then lol, it turned out the insulation had stripped off the wires of the tss and was occasionally contacting eachother. So replaced with oem part as i had used a non oem one when i rebuilt the trans, and i think thats where i screwed up lol. But shes back to good as new thankfully.
Thread
Thread Starter
Forum
Replies
Last Post
