is there a speical tool or something to disconnect the hydrolic line to the transmission? is there something i can rig up to diconnect it?

this is a 2.5L 5 peed i dkn the right name for the tranny

 

the hydraulic line has a plastic sleeve over it, push it inward toward the center of the tranny, it will release some "fingers" that secure the line into the release bearing. There is a springloaded check valve inside that wont allow fluid to pour out.

 

hydraulic line into the tranny? Are you talking about the master cylinder quick connector for your slave cylinder??

There is a special tool for that....But i've never used it......with a careful hand, and a couple small flat screw drivers, it can be done. I've done it three times now.

 

This is what the actual tool looks like:
[IMG][/IMG]

I don't remember where I even got it at anymore because I've had it for ages. It works really well but it's definitely not necessary.



Allen