Dose any one know where I could get a drawing on line for 2.3L M5OD bellhousing bolt pattern I would like to make a adapter plate for it to fit a tdi alh diesel I have the drawing for the Alh!

http://www.haywood-sullivan.com/vana...wing_small.pdf

pleaes help if you can! Thank you Jhon

 

you asked this on the other forum without much luck. why dont you find one in a junk yard and trace it out. nobody is going to have the bolt pattern drawn out to a close enough spec that it will bolt up, you ned to mock up on the transmission.

 

Sorry my looking for a drawing like the link that I have there if there is a drrawning for an engien in that full detale there should be for a trany? I dont need a trany and the junk yards want $300 to $500 a wast for just a bolt pattern. Last week I bought a blowen tdi alh for the bolt pattren about a day latter I found the drawing which is in the link above so that was a waste! Not going to do that again if it is as easy as aksing for a bit of help!