i have 4 4.5 to 5.5 inch wheel adapters , i am looking to use my 4 classic turbine rims

just looking for feedback about the reliability of these adapters , i never used them before

 

Make sure your original lugs are cut shorter (as to not stick past the adapter), make sure they are torqued to spec and you should be fine. Quite a few people run them just need to check the torque occasionally IMO.

 

thank you for that

also what is the maximum width of adapter that is safe to use

 

The wider you get the harder it is on balljoints and wheel bearings. So remember that.

I personally wouldnt go any more than 2"

I want to put 2" spacers on my F350 so I would imagine spacers would be fine on a ranger. A lot of guys run 2" on 3/4 and 1tons.

 

okay thank-you for that info