Ford 9' disk break converstion
#1
#2
http://www.summitracing.com/parts/SU...el%7cFord+9+in.
here ya go...im not 100% sure this is the right one but it looks to be right
here ya go...im not 100% sure this is the right one but it looks to be right
#3
#4
I made my own. I used 3/8 plate for caliper mounts, front rotors from a 1/2 ton ford, and front calipers from a chevy.
If I were to do it again, I would order the caliper brackets from ruff stuff, it was a PITA to make my own.
Also, I think that TSM makes a kit. It would seem pricey, but think about sourcing all the parts seperately, then trying to make them work. It's probably worth it.
If I were to do it again, I would order the caliper brackets from ruff stuff, it was a PITA to make my own.
Also, I think that TSM makes a kit. It would seem pricey, but think about sourcing all the parts seperately, then trying to make them work. It's probably worth it.
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
Rooks
OLD - Engine & Drivetrain
12
10-18-2013 01:48 PM