Yet another drive shaft question
#4
Shouldn't need one...though i'm unsure on that style suspension. I havn't seen any asteric's on the 6" lifts for them saying a longer front shaft is needed. IDK.
Rear....swap to a 1piece and you'll be good to go. 6" lift kit comes with only about 4" of lift for the rear, and there's trucks out there with more lift running stock shafts without any issues.
Good to go on the rear if 1piece, unsure on the front shaft.
Rear....swap to a 1piece and you'll be good to go. 6" lift kit comes with only about 4" of lift for the rear, and there's trucks out there with more lift running stock shafts without any issues.
Good to go on the rear if 1piece, unsure on the front shaft.
#7
YOu have a 2 piece rear shaft right.. The hanger bearing will put it at too much of an angle.. and it wil vibrate until you're up past about 20mph.. I had that problem.. so I just got a custom one piece built.. I also got a custom front one made cuz mine wasn't long enough when I was flexed out, as it would bind..
Thread
Thread Starter
Forum
Replies
Last Post
2001fordranger
Drivetrain Tech
6
03-05-2011 07:06 PM