Transmission Pan Gasket
#1
#2
No kind of sealant on the O-rings for the filter. Maybe a little atf for the initial install of it.
Can't remember if my gasket was rubber or cork. Either way i did the same method of using a THIN layer of black rtv on the pan surface, placed the gasket on, then another THIN layer on top of the gasket. I snugged the bolts up and let it setup (for as long as possible, within reason)
Don't overtorque them, snug should do.
Can't remember if my gasket was rubber or cork. Either way i did the same method of using a THIN layer of black rtv on the pan surface, placed the gasket on, then another THIN layer on top of the gasket. I snugged the bolts up and let it setup (for as long as possible, within reason)
Don't overtorque them, snug should do.
Thread
Thread Starter
Forum
Replies
Last Post
ElleShooTiger
4.0L OHV & SOHC V6 Tech
1
09-10-2010 10:23 AM
FULLSCALE
OLD - Engine & Drivetrain
6
07-11-2010 07:17 PM