DIY Roll Pan
#1
The following 2 users liked this post by PaulE01:
Fordzilla80 (06-23-2022),
RonD (06-26-2022)
#2
Damn Paul! Quit putting these ideas in my head! Seriously, you're so skilled, and obviously patient, that you keep making these projects look easy. I must've spent 30 hours replicating your tailgate re-skin project. And my clean little 2000 stepside is just my daily driver. I'm already busy building a '49 Mercury woody wagon. My wife and neighbors thought I was bat-sh*t crazy when I dropped that project to work on the Ranger that looked perfectly fine to start with!
Seriously, I REALLY enjoy your tutorials and I'm looking forward to the second segment on the rollpan!
Thanks again,
Rick
Seriously, I REALLY enjoy your tutorials and I'm looking forward to the second segment on the rollpan!
Thanks again,
Rick
#3
Damn Paul! Quit putting these ideas in my head! Seriously, you're so skilled, and obviously patient, that you keep making these projects look easy. I must've spent 30 hours replicating your tailgate re-skin project. And my clean little 2000 stepside is just my daily driver. I'm already busy building a '49 Mercury woody wagon. My wife and neighbors thought I was bat-sh*t crazy when I dropped that project to work on the Ranger that looked perfectly fine to start with!
Seriously, I REALLY enjoy your tutorials and I'm looking forward to the second segment on the rollpan!
Thanks again,
Rick
Seriously, I REALLY enjoy your tutorials and I'm looking forward to the second segment on the rollpan!
Thanks again,
Rick
Thanks for the kind words as always Rick! To be honest, after I finished the roll pan I ended up not being happy with it so I made another one. Its pretty much the same but the lines and bends are a bit more sharp. Hopefully I can get it welded on in the next little while
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: roll pan
Paul Spickard
OLD - Interior, Exterior, Electrical, & Misc.
0
06-30-2010 02:35 PM
For Sale: Steel Roll Pan (TX)
WacoRanger
OLD - Interior, Exterior, Electrical, & Misc.
14
01-24-2010 04:08 PM