I am looking into getting an exhaust for my truck but I don't have a ton of money to throw into it. I just wanted to know how much you guys paid for you custom exhaust to see if I should go that route or if I am better off buying a cat-back and installing it myself.

 

Use the search function, this topic comes up every few days, there is so much info on this site about this already........... To answer your question, it was cheaper (and better IMO) to get it custom, then it is exactly what you want, and allot of times, its cheaper.

 

160 for a borla Turbo XS muffler, 75 for 2.5" Pipe from the last back back like 10 bucks for a Magnalflow Tip like 18x3" or something i think

 

I paid $80 for a Borla proXS muffler off of ebay and installed it for free. If you know how to weld you mine as well do it yourself.

 

I agree with graygoose. Mine was $500 even custom bent from the CAT back

 

I paid $60 for a borla pro xs muffler and $40 to install. Install included 2.5" pipe from the cat to the muffler and a 2.5" turndown right after the muffler. I could have installed it myself, but for $40 I let someone else get dirty.

 

$30 for a new 40 flow... $40 for 18" stainless steel rolled tips... $100 for cat back custom piping and hangers... so... $170 total... and now its all screwed up from getting rear ended...

 

you can buy pre-bents and a single in/dual out flowmaster 40 series, and a set of tips.. cut it to fit and weld/hanger it up.. works good

 

Happened to me onn my F150... I was slightly pissed to say the least.

 

i paid 185 for custom bent duals from the cat back

 

Who needs a catback.

Throw a Flowmaster 10 series 1 chamber muffler on there, and dump it right after the cats. 60 bucks for the muffler and better sounding than a full catback!!!!

 

i paid around 200 for mine

 

200 sumthin for my flowmaster 40 with 3x21in tips

 

225 for flowmaster single in dual out.