1991 Manual Transmission Sensor help
Thread Starter
|
Member
Joined: Sep 2016
Posts: 1
Likes: 0
From: Gainesville, GA
1991 Manual Transmission Sensor help
I'm swapping the transmission on my ranger and I know it has two sensors. i know one is for the backup lamp but can't figure out what the other sensor is and it is broken. Anyone have an idea?
Welcome to the forum
Backup is a switch, just FYI
Only other wired connection on a 1991 Ranger manual trans(M5OD-R1) would be the VSS(vehicle speed sensor), it would be with speedometer cable hookup on drivers side of tail shaft housing.
It would look like this: http://www.therangerstation.com/tech...peedsensor.gif
and this: http://www.therangerstation.com/tech.../vss_test1.JPG
Some Explorer M5OD-R1 transmissions had a Neutral switch, Rangers never did.
Backup is a switch, just FYI
Only other wired connection on a 1991 Ranger manual trans(M5OD-R1) would be the VSS(vehicle speed sensor), it would be with speedometer cable hookup on drivers side of tail shaft housing.
It would look like this: http://www.therangerstation.com/tech...peedsensor.gif
and this: http://www.therangerstation.com/tech.../vss_test1.JPG
Some Explorer M5OD-R1 transmissions had a Neutral switch, Rangers never did.
Thread
Thread Starter
Forum
Replies
Last Post
fords4wheeling
2.9L & 3.0L V6 Tech
4
Feb 17, 2013 04:25 PM
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
1
May 7, 2009 04:43 PM
