1999 ranger wont start after transmission install
Thread Starter
|
Member
Joined: Dec 2010
Posts: 19
Likes: 0
From: St.paul,MN
1999 ranger wont start after transmission install
I have a 1999 ford ranger Xlt 4x4 just got done putting in the transmission (Auto 5r55e) went to go start it up and nothing, no cranking nothing its like when you have it in drive and try to start it( but its in park), I can hear a relay click and engine parts buzz and thats about it, i checked all my wiring clips and eveything is plugged in nice. what could this be? 
Member
Joined: Oct 2005
Posts: 2,804
Likes: 6
From: Northern IL
Did you swap the transmission range sensor? Also try neutral.
also if you didn't adjust the linkage correctly in wont start. Try moving the gear selector while you try and start. If it does you need to adjust that linkage.
also if you didn't adjust the linkage correctly in wont start. Try moving the gear selector while you try and start. If it does you need to adjust that linkage.
Thread
Thread Starter
Forum
Replies
Last Post
2.3 ranger
SOHC - 2.3L & 2.5L Lima Engines
1
Jul 7, 2013 03:52 PM
2.3 ranger
General Technical & Electrical
0
Sep 22, 2012 08:43 AM
Grease Monkey
SOHC - 2.3L & 2.5L Lima Engines
8
Jul 30, 2011 01:58 PM
503_94ranger_541
Drivetrain Tech
40
Oct 23, 2009 07:58 PM
