General Ford Ranger Discussion General discussion of the Ford Ranger that does not fit in any other sub-forum.
Sponsored by:
Sponsored by: DashLynx

Newbie here, need help please...

Thread Tools
 
Search this Thread
 
  #1  
Old 03-26-2013
84ranger2.0's Avatar
Member
Thread Starter
Join Date: Mar 2013
Location: Palmyra, MI
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Newbie here, need help please...

Hi everyone, new here. I am having a couple issue's with my Ranger, it is a 1984 2.0, 4 speed, what its doing is running real rough and will not idle, but runs good at higher idles, as long as I keep the rpm's up I can drive it down the road fine but it does smoke a little and seems to be a little rich, with a little popping from the exhaust. Also when I turn the key on I get a steady clicking noise coming from the carb. Any help would be appreciated, thanks

Things that I have already changed are
Head Gasket,
Had Head Redone, new valves. pressure tested,
Plugs, Wires, Cap, Rotor,
Fuel Pump, Fuel Filter

Was running this way before all the new parts, still runs the same after, I'm clueless at this point
 
  #2  
Old 03-27-2013
06RangerXLT's Avatar
Member
iTrader: (2)
Join Date: Feb 2011
Location: Halton Hills, Ont
Posts: 1,685
Likes: 0
Received 5 Likes on 5 Posts
id check a few things. first, no idle says the carb needs to be rebuilt and re-setup. if the truck still has cats, they could be clogged, causing too much backpressure at idle and shutting the motor down. if its backfiring, the timinig may be off, you could have an exhaust leak or again the carb needs to be adjusted.

thats about as for as i can help ya, as i dont know the motor personally. around here those trucks are for the most part off the road from rust.
 
  #3  
Old 03-27-2013
84ranger2.0's Avatar
Member
Thread Starter
Join Date: Mar 2013
Location: Palmyra, MI
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Thats kinda what I was thinking, the carb most likely could use a rebuild the truck has sat for the past 3 years. The carb and cat are the only things left to do everything else has been done. For an 84 ranger it has no rust on it everything is still original could use a paint job though, the only bad spot is the drivers floor board has been patched up, and it rides down the road like a Cadillac lol
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
XHILR8N
8-Cylinder Tech
10
4 Days Ago 11:49 AM
annguyen1981
General Ford Ranger Discussion
13
12-05-2013 02:35 PM
immortal_vision
Suspension Tech
4
09-11-2010 05:52 PM
demaxx1
Drivetrain Tech
2
11-24-2009 09:50 PM



Quick Reply: Newbie here, need help please...



All times are GMT -6. The time now is 06:27 PM.