ok its a 96 ranger I saw built on speed. Thing is awesome. But look at the quarter panels, they look stock (correct me if im wrong). I want to push them out a bit. How do you do this? heat and a scissor jack and a good rectangular piece of wood? any info or a link here?

 

http://therangerstation.com/tech_lib...erFlaring.html

 

We have a winner. thanks boss

 

You can also buy pre runner fenders

 

theres that word buy haha im kidding. I would be into this if I was going the fiberglass/prerunner/long travel direction. But Im just looking for the width of fender flares without fender flares. stretching my panels seemed like the way to go. Im only going for an inch max

 

btw those arent stock bed sides the wheel open goes to close to the body line. those are probably fiberglass

 

stock beds sides can push out a lot, just go by the article and your set