Looking at this Explorer, what do you think?
#1
Looking at this Explorer, what do you think?
I'm looking at getting this Explorer asap. I don't car about the front gears missing and all, I just want to make sure this thing is somewhat "safe" if not what would you correct to make it safe so that I can drive it. I'm going to be converting this one to 4WD as well. Should be a fun project. And can you tell what axle is under the front?
Brenton
Brenton
#5
It's not about flexing down here (Alabama, Georgia, Florida) for the most part. Once you get south of Atlanta its pretty flat, mud/swamp is the biggest thing down our way.
Agreed!
Tys 4x4
imo, i'd lose the blocks, and a leaf or two, add some slightly smaller tires, and i'd be good to go. but idk about what you want.
imo, i'd lose the blocks, and a leaf or two, add some slightly smaller tires, and i'd be good to go. but idk about what you want.
#10
http://i360.photobucket.com/albums/o...s/FILE0216.jpg
wtf is up with that stearing piece is it bent up and it looks like its about to rub the tire. if they bent the cast i wouldn't drive it its only time till it will snap off.
wtf is up with that stearing piece is it bent up and it looks like its about to rub the tire. if they bent the cast i wouldn't drive it its only time till it will snap off.
#15
#16
It almost looks big enough to be a 60, but its probably a D44. The tubes look too small to be a 60.
where do i start?
-The rear axle almost looks like a 7.5, but its probably 8.8.. still too small for tires that big IMO.
-Front shackle angles need to be fixed
-steering is sketchy as *****, seriously wtf is up with the "high steer" arm
-do you get the front axle shafts?
-you probably want a HP front axle to help with the pinion angle
-it looks like the rear shackle angles could use some help.
-front lift blocks have have got to go.
but for 2k why not..
where do i start?
-The rear axle almost looks like a 7.5, but its probably 8.8.. still too small for tires that big IMO.
-Front shackle angles need to be fixed
-steering is sketchy as *****, seriously wtf is up with the "high steer" arm
-do you get the front axle shafts?
-you probably want a HP front axle to help with the pinion angle
-it looks like the rear shackle angles could use some help.
-front lift blocks have have got to go.
but for 2k why not..
Thread
Thread Starter
Forum
Replies
Last Post
Boomzilla
Exterior Semi-Tech
1
10-09-2010 09:37 AM
04_xlt_4.0_4x4
Wheels & Tires Semi-Tech
14
08-22-2010 07:40 AM
rangerkidSHSU
Ranger-Forums Office
4
03-11-2009 08:52 PM