Found a topper for my Ranger but don't know
well first, measure it or get the measurements. it might be close enough to fit, but it will never fit like a shell made for the ranger. probably wont follow the body lines either. but if its a good deal, if it fits, and if you can live with it then go for it.

The topper I'm looking at is off a 1999 sonoma which has a 10 degree cab and the ranger has a 7 degrre cab. This concerns me.
I had an s10 cap on my ranger at one time and the cap is about 1 to 1.5 inch longer then the ranger bed so there was a gap between the tailgate and rear door of the cap about 1 to 1.5 inch, and the roof of the cap was 1 to 1.5 inch lower then the roof of the ranger. Other then that it fits
Thread
Thread Starter
Forum
Replies
Last Post
ccernst
General Technical & Electrical
16
Jan 5, 2011 09:53 AM
buggman
Exterior Semi-Tech
4
Jun 26, 2010 07:19 PM




