04-05 Valence Question. Also lift question.
#1
04-05 Valence Question. Also lift question.
I read on here that there are 4x4 XLT w/ foglights valences for the 04-05 Ranger and FX4 valences w/ foglights. What is the difference between the two?
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Also. I am looking at lifts. I read through the tutorial on the 3in BL and it looks a little two extensive for me. I am looking into 1 to 2 inch basic lifts, on a budget. Since I am 2WD and have coil springs I am thinking 4, one inch coil spring spacers. 2 for each side in the front. And Add-A-Leaf kits for the back. One leaf adds a little under 2 inches.
Will this work? Will I have to do any modifications to my vehicle if I do 1 to 2 inches like you have to for a 3 inch?
Thanks guys. Don't know what I would do without you.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Also. I am looking at lifts. I read through the tutorial on the 3in BL and it looks a little two extensive for me. I am looking into 1 to 2 inch basic lifts, on a budget. Since I am 2WD and have coil springs I am thinking 4, one inch coil spring spacers. 2 for each side in the front. And Add-A-Leaf kits for the back. One leaf adds a little under 2 inches.
Will this work? Will I have to do any modifications to my vehicle if I do 1 to 2 inches like you have to for a 3 inch?
Thanks guys. Don't know what I would do without you.
Last edited by Masteratarms93; 04-27-2010 at 06:33 PM.
#2
01-04 Fx4 Valences have a cut-out of the special "J-hook" towhooks. That's the only difference between them. '05 Fx4 valences are exactly the same as a normal XLT 4x4 valence.
The lift questions...I'm not too sure. I'd just 3" spindle lift it and put a shackle in the back. That'll get you 3" front, 2" rear lift. You can then run 31's.
The lift questions...I'm not too sure. I'd just 3" spindle lift it and put a shackle in the back. That'll get you 3" front, 2" rear lift. You can then run 31's.
#3
Thread
Thread Starter
Forum
Replies
Last Post
alwayssideways
Member Introductions
13
08-16-2009 08:54 PM
TommyC
General Ford Ranger Discussion
26
08-16-2006 04:51 PM
n3elz
Suspension Tech
10
06-21-2005 08:08 AM