Hi i have a 1991 ranger 2wd. 3.0 v6 automatic. truck has 90000 miles and i have replaced the fuel pump and fuel filter. when i get in and turn the key pump kicks on but when i crank it it just keeps cranking but wont start! if i turn the key on and off about 8 times it will start but when it finaly starts and i accelerate it bogs down and will not hold a steady RPM. but after it stops boggin down it runs perfect. if anyone has some addvice i would relly relly appriciate the help you can email me on here or message back or contact me at 614 629 4304 thanks cody

 

possible injectors/got a bad pump...happens

 

Fuel pump RELAY

 

just replaced the pump and i put injector cleaner. anything else

 

Fuel pressure regulator? Sounds like low fuel pressure because the regulator is nfg.
...Terry

 

well just went to start it and did the same bs, also now the motor is shaking. I'm good with vehicles and this is just pondering the heck out of me

 

well i finaly got it done all it was was the hose that runs from the fuel pump to the sendin unit in the tank thanks for all the help