The ranger is at home, I want to do some design work in autocad, this afternoon if i have time. If someone has a minute and can measure a few things on a 98+ 4wd, extended cab, short bed ranger that would be awesome.

I need

A) from the rear axle to the back of the cab
B) from the rear axle to the rear of the bed
C) width of the frame right behind the cab


thanks!

 

Bed cageeeee

 

beard, i have to say.. you must be BAWWWWLLLIINNN status.. Or atleast your truck will be lol..

 

or broke, so which is it?

nah i just like to toy with it and i find good deals. IMO

 

If it wasn't raining here I would be all over it for ya. I seriously feel like I'm living in Seattle right now. All it does it rain here lately.

 

haha.. well, i know how the broke part is lol.. ALL my money goes to the truck.. well, All the money the wife will allow lol.. I wish I had money to be able to do Half of what you have done with your truck!

 

You get the measurements yet, I can do it if you havnt got them yet??

 

not yet. if you have the time that would be awesome. if not ill just wait until tomorrow to get them.

 

gimme a few mins...



on the axle centerline to cab, you want those parallel to the ground?

 

37 1/2 from back of cab to axle centerline.

36 1/2 from rear edge of bed floor to axle centerline.

on your own mr. 'i have fuel cell and no stock tank'. lol...I can't get a good measurement of that.


All are approx and eyeballed on my truck with stock K leafs and 6400 shackles. axle to back of bed was a pain....gonna have to confirm on your truck before cutting...but of course you already know that. lol.

 

perfect. thanks shane, all i needed was rough numbers at this point. i think the frame is around 32.5" wide there anyway. forgot about the fuel tank in the way.