More Frame questions
#1
#2
RF Veteran
iTrader: (1)
That's a rare model
Yes, you could cut 6" out of front section of rear frame and also 6" off rear section, so might be better, easier to just grind off the rivets and swap rear frames
And you may be able to SELL an intact Long bed frame to get back some costs, these long bed frames rust out like any frame, lol and are much harder to find
People also like to make Extended Cab Long beds, which was not a factory option, so are looking for Long Bed frames AND Beds
There were only 2 sizes of rear frames, short bed(6ft bed) and Long bed(7ft bed)
Regular cabs could have either
Extended cabs could only have 6ft
Front frames had 4 models
2WD Regular cab
2WD Extended cab
4WD regular cab
4WD extended cab
4WD had boxed frames in the front for axle mounting and less flexing
Yes, you could cut 6" out of front section of rear frame and also 6" off rear section, so might be better, easier to just grind off the rivets and swap rear frames
And you may be able to SELL an intact Long bed frame to get back some costs, these long bed frames rust out like any frame, lol and are much harder to find
People also like to make Extended Cab Long beds, which was not a factory option, so are looking for Long Bed frames AND Beds
There were only 2 sizes of rear frames, short bed(6ft bed) and Long bed(7ft bed)
Regular cabs could have either
Extended cabs could only have 6ft
Front frames had 4 models
2WD Regular cab
2WD Extended cab
4WD regular cab
4WD extended cab
4WD had boxed frames in the front for axle mounting and less flexing
#3
#4
RF Veteran
iTrader: (1)
Thread
Thread Starter
Forum
Replies
Last Post
Scrambler82
Fabrication & Tool Tech
12
01-28-2013 03:37 PM