I don't know if you want more than this, but these are hosted by myself and won't be deleted or have a host run out.

 

Man, I just noticed, I need to repaint my undercarriage.

 

Thats a good start, but I want the whole shebang! Start to finish, lots of photos so it can be a very complete How To and anytime somebody asks about it they can just be linked there.

 

I have already cranked mine, so I am out. You can have those though. It is too dang hot to go out and dink around with it again...not to mention taking it in to get realigned lol

 

No prob, a couple people volunteered to do it already...

 

cool

 

You also need to get it aligned. Unless you like buying tires.

 

Ok, going out to do the crank and how 2 now :-) be back later with a full write up and pics!!!

 

So then.. hows this comin..?

 

lol

Brenton

 

[waits patiently]

 

lmao, 2 pages and tons of people later....no write up.... I would do it if it didnt throw your alignment off....i was thinking just an inch or so to lift it up some wouldnt hurt the alignment that much, but i think ill just leave it alone...

Rocky

 

Just hold tight until you need tires, and do it right before you go in to get the tires mounted. You should always get a front end alignment when you get new tires anyway.

 

im going to be cranking mine with zack (redneckstone) once i get my 33's.

If i remember i will take some pix and make one.

 

Ok, since no body else has done it...

I am off of work tomorrow & can't drive my truck anyways. I figured that I'll go ahead & take pics...

Jason, do you want me to do a wirte up or just give you the pics?

Brenton

 

BrentON, if you can do the write up to that would be great, but if not its alright. Anything would be good after all the people flaked...

THANKS!

 

BrentON*...lol, j.k!

Brenton

 

Edited.. Better now? lol.. Thanks again.

 

I'll do one too, how about a body lift how to? mine should be coming in the end of this week.

 

Never seen a body lift how-to.

Question: How does one pretend to crank the t-bars?

 

That would be awsome! Take lots and lots of photos!

 

...take so many you can make a flipbook lol

 

Listen to this crap...

I went & tried to do mine today & they woulen't harley move @ all & I even had teh front end off the ground. So after being pissed about that I went to a local auto shop & went to get them to do it & to get my front-end alligned & the lil ***** say that I need new upper ball joints & a new tie rod socket or something like that. So I didn't do it, but I got pics of the bolt itself, but I'm sure that everyone else has one of those too...

Brenton

 

Well that sucks..your problems, I couldnt care less about this...

Ok, lets try this. If somebody can take pictures of the bolts, multiple angles, the wrench on the bolts, the wrench size I can work with that. No need to actually do it. Thanks.